Flood King Features & Benefits
• Top mounted, dual three-stage vacuums
increase airflow efficiency and vacuum
performance – improved water recovery
• Ergonomic, upright, compact design for
easy maneuverability and easy storage
• Rotationally molded body with a lifetime
warranty for maximum durability
• Three-stage filtration system increases
pump life
• Runs on a single 25’ cord at only 13 amps
• Auto-dump, 10.5 gallons per minute with a
9 gallon recovery tank

The Vacuum Pac, with it’s patented, portable design and high-end technology, has two powerful vacuum motors that can generate maximum suction. And because it is portable, the Vacuum Pac can be handcarried anywhere in a structure. Truckmount units must stay outside the structure, and every foot of hose deducts 1 cfm of vacuum power. When compared to truckmount units, the Vac Pac can apply all of its suction power right at the source of the water, losing no cfm due to 24, 50 or 100 ft. of hose.

The Society for Cleaning Restoration Technicians (SCRT), formerly ISCT, performed a market study of extraction devices at Shaw Industries. The results from that testing can be seen in the published report from www.isct.com. In that independent study by restoration professionals, the Hydro-X Xtractor with Hydro-X Vac Pac pulled more water out of the carpet and pad than any other product on the market today, in one case pulling over 40 gallons or 320 pints more water out of the structure than the next best tool. How much longer would it have taken to dehumidify 40 gallons (320 pints) of water if the restorer had not used the Hydro-X? This study looked at using truckmounts with the different extraction tools. In every case, the Hydro-X Vacuum Pac extracted more water with the different extraction tools than the truckmount with the same or similar tools.

The Vacuum Pac can be run separate from the Hydro-X Xtreme Xtractor and can run with standard wands, water claws, and any other extraction tool allowing for a 2 in. connector.

Portable Truckmount Performance

The patented Hydro-X Vacuum Pac was designed to provide suction power superior to any other portable or truckmount unit on the market today.

Any standard extraction tool, from a wand to a water claw, to the Hydro-X Xtreme Xtractor, can be combined with the Vacuum Pac allowing for extraction on hard surfaced floors and hard to reach areas for the Xtreme Xtractor.

Features

• Portable—applies all of its suction power at the source
• Rust and corrosion resistant stainless steel construction
• Built to withstand daily use
• Heavy duty electricals
• One year warranty on parts and labor
• Can be used separately from the Hydro-X Xtreme Xtractor
• Full stainless steel chassis
• Industrial vacuum and water pump
• Optional port for other vacuum needs
• Dual vac motors

• Spec Sheet
• Manual

The Phoenix Hydro-X Xtractor is the most effective and efficient extraction tool on the market today. The Hydro-X Xtractor’s patented Suction Roller provides both suction and compression—forcing water to the surface then sucking the water away, not allowing the water to be reabsorbed back into the carpet and pad. No other extractor today can pull as much water from the carpet and pad as the Hydro-X Xtractor.

The Hydro-X Xtractor is steerable and self-propelled with variable speeds. One restoration technician can operate the unit and dry a 1200 sq. ft. structure with carpet and pad in under 2 hours!

Insurance companies recognize the Hydro-X as the best tool on the market and allow for “special extraction tool” rates, sometimes up to three times higher rates per sq. ft. than regular extraction tools.

The Society for Cleaning Restoration Technicians, formerly ISCT, performed a market study of extraction devices at Shaw Industries. The results from that testing can be seen in the published report from www.isct.com. In that independent study of restoration professionals, the Hydro-X Xtractor with the Hydro-X Vac Pac pulled more water out of the carpet and pad than any other product on the market today, in one case pulling 40 gallons (or 320 pints) more water out of the structure than the next best tool.

Industry experts all say its easier to extract water out of a structure than it is through dehumidification and air movement. If you want to cut a DAY(S) off of your drying process, a Hydro-X Xtractor is a necessity.

The Hydro-X Xtreme Xtractor tool can be connected with the Hydro-X Vacuum Pac, other portable extractors or truckmounts. However, the SCRT W.E.T. Study showed best performance is when combined with the Hydro-X Vacuum Pac.

Not all Carpet and Pad configurations are the same.

Every specific combination of carpet and pad will require the restorer to check and determine how many passes the Hydro-X must make to dry the floor. One structure could have multiple different carpet/pad configurations; thus the restorer will have to check each one to determine the proper amount of passes.

Note: The Xtractor is to be used for ONLY carpet and pad. Running on hard surfaces (like glue-down carpet) will not allow for a proper vacuum seal and could damage the perforated roller.

Determining a plan to dry with the Xtreme Xtractor.

Observe the type of carpet and pad installed.

Next, run the Hydro-X Xtreme Xtractor about 2-3 feet into the corner and back out (making 2 passes over the wet floor). Pull back the carpet in the corner, then pull back the pad. Squeeze the pad to determine if water leaks from your fist. If no water drips, then that is the amount of passes needed to dry this particular carpet and pad combination. If water drips from your hand after grabbing the pad, then continue running the Hydro-X into the corner until the correct amount of passes is determined to dry the floor.

Note: The speed dial on the Hydro-X can be turned up to help reduce the amount of time it takes to complete the drying process. The speed has a direct effect on the amount of water extracted in one pass. Historically, fast speed is appropriate for easy extraction type carpets and pad, such as cutpile, and slow speed is appropriate for hard extraction type carpets and pad, such as berbers.

Features

• Patented suction roller
• Self-propelled with positive chain drive—no belts to break or adjust
• Variable speed for every carpet and pad condition
• Extracts in both forward and reverse
• Rust and corrosion resistant stainless steel construction
• Built to withstand daily use
• Heavy duty electricals
• One year warranty on parts and labor

Phoenix Hydro-X Xtreme Xtractor Specifications

• Spec Sheet
• Manual

Phoenix Hydro-X Xtreme Xtracator Restoration Industry’s most efficient and versatile solution for removing water from carpet and pad. Features steering. Self-propelled movement. Multiple speeds. Stainless steel chassis. Patented Xtreme Xtracator roller, 2.5 Amps 115 Volt/60Hz. 80 Lbs. 4025600

Phoenix Hydro-X Vacuum Pac Restoration Industry’s most efficient and versatile solution for removing water for carpet and pad. When used with the Xtreme Xtracator, the patented Vacuum Pac outperforms all truck mounted vacuum sources. 115 Volt/60 Hz. 74 Lbs. 4025601

Flood Cleaning Equipment ,Water Extractors, Phoenix Hydro-X Xtreme Xtracator, Phoenix Dehumidifier, Used Dehumidifiers, Dehumidifier Parts and Service, Air Mover, Viking Air Mover, Power Distribution, Spider Box, Electrical Panel, Flex Ducting, Generators, Magnum Generators, 50 Amp Electrical Cords, Lay Flat Tubing, Power Cords, Water Damage Equipment Repairs, all Natural Disaster Equipment, all Flood Cleaning Equipment, Used Drying Equipment